Michigan Short Track Racing Club: measuring quick change for axlesi - Michigan Short Track Racing Club

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

measuring quick change for axlesi

#1 User is offline   Gary Pelky Icon

  • Crew member
  • Icon
  • Group: New Members
  • Posts: 40
  • Joined: 19-June 12

Posted 03 January 2015 - 08:12 PM

I have a quick change I need axles for what is the best way to measure for axles
0

#2 User is offline   governor Icon

  • Touring series champion
  • Icon
  • Group: Senior Members
  • Posts: 2,721
  • Joined: --
  • Gender:Male
  • Location:Charlotte MI.
  • Interests:Family and Racing

Posted 03 January 2015 - 08:20 PM

I use 2 piece of 1/2" conduit, make sure you are in the spool the same from each side, better to be a little long as you can always
cut them off if needed.

Gov
A Passion for Modified Racing
0

#3 User is offline   proglide Icon

  • Full time racer
  • Icon
  • Group: Members
  • Posts: 94
  • Joined: 17-November 08
  • Gender:Male
  • Location:clio, mi.
  • Interests:powerglide builder, ford and gm rear ends, motors

Posted 03 January 2015 - 11:24 PM

go to the winters performance web site, they have a chart in the quick change section that allows you to measure your axle tube length and cross reference to the correct axle shaft lenght for your set-up. it has charts for wide 5 and 5 x 5. the same info used to be in the speedway motors catalog but i see it isn't in my newest catalog.
0

#4 User is offline   Gary Pelky Icon

  • Crew member
  • Icon
  • Group: New Members
  • Posts: 40
  • Joined: 19-June 12

Posted 03 January 2015 - 11:34 PM

Thanks guys for the info got it figured out
0

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users